HT Combined Panel roll forming machine Detailed Product Description1.IntroduceEPS Sandwich panel roll forming machine consists mechanical controlling, motor controlling and additional equipmentFeatures1).Beautiful appearance, low noise, high efficiency 2).Multiple function: besides corrugated sandwich panels, this line can be used to produce simple corrugated sheets, and sandwich panels. 3)The line employs advanced PLC and sets the panel length and cuts the panel automatically. 4).The main body is welded with type "H" section steel as its material, strong strength. 5).The length can be as required sizes, the width is fixed.2,Main technical parameters2.1 Gear/Sprocket driving, 13+26-step to form2.2 Material of rollers:45steel,quenched HRC58-62 with polishing2.3 Material of roller shafts:45#steel,quenched HRC58-62 with polishing2.4 Shaft Diameter=Φ90mm, Precision Machined2.5The Tooling is configured using pre-machined Spacers, which are designed to allow for different width of panel to be formed.2.6 Main Motor=7.5kw+3.0kw+2.2kw+0.5kw2.7 Transducer=0.4kw2.8 Forming speed approx.:5-15m/min2.9Pump 4 set3.0Cutting device3.1Amount of cutting:2 sets 3.Forming machine This machine is configured in accordance with panel form drawing given (refer to the drawing). The same is used to form color-steel facings with plate like structure, welded frame and gear-chain transmission. Specification of color-steel facings for wall panels and inside roof panels: 1,000mm in width and 0.4 0.7mm in thickness. Specification of color-steel facings for outside roof panels: 1,200mm in width and 0.4 0.7mm in thickness. 3.1The unit includes: 3.11One set machine for top sheet forming It is put on a high platform, which is used to press and form inside roof skins and wall skins. The machine, which is infinitely speed-variable by way of changing frequency, shall be with 11 forming rollers of 75mm in diameter and with the power of 4kw and maximum forming speed 8m/min. 3.12One set machine for bottom sheet forming It is installed on the ground, which is used to press and form corrugating roof skins and wall skins. As to outside roof skins, the machine shall be with 21 forming rollers of 75mm in diameter and maximum forming speed 8m/min. For wall skins, the infinitely speed-variable machine shall be with 11 forming rollers of 75mm in diameter and with the power of 7.5kw and maximum forming speed 8m/min.